Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
builderpages:davetypeguy:start [2016/08/08 09:03] davetypeguy |
builderpages:davetypeguy:start [2016/08/16 02:55] (current) davetypeguy |
||
---|---|---|---|
Line 41: | Line 41: | ||
{{: | {{: | ||
- | Current status: All sockets are installed. Almost all resistors are installed. VGA, keyboard and mouse adapters are installed. I am waiting for the remaining parts to arrive to finish up the soldering work. I also need to fix the reversed diodes and the 2.5K resistor. I will then run a voltage check across the board to ensure no solder bridges or shorts, burn the firmware and start the process to bring it up. | + | Partial success. I was finally able to solder |
- | {{: | + | {{: |
+ | |||
+ | I have redesigned the adapter boards to make them easier to solder by using longer pads under the chip as shown below. This is the PQFP-100 board. The TQFP-128 has been similarly redone. These adapters will be included with the final release boards if they are still needed . (And yes, the pin number for the start of the fourth port should read 81, not 71. I made a little mistake with the numbering.) | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Current status: All sockets are installed. Almost all resistors are installed. VGA, keyboard and mouse adapters are installed. I am soldering in the last few items, then I will run a voltage check across the board to ensure no solder bridges or shorts, burn the firmware and start the process to bring it up. | ||
+ | |||
+ | {{: | ||