Differences
This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
|
|
builderpages:plasmo:z80sbc64:getting_started [2020/01/11 00:32] plasmo |
builderpages:plasmo:z80sbc64:getting_started [2020/01/11 10:33] (current) plasmo |
| |
Type '**c0**' to copy ZMon64 to the bootstrap RAM area which is located in a different bank protected from modification by normal software. Power down the board and move the mode jumper to "RAM bootstrap" position. Reapply the power and you should see the ZMon64 sign-on message. | Type '**c0**' to copy ZMon64 to the bootstrap RAM area which is located in a different bank protected from modification by normal software. Power down the board and move the mode jumper to "RAM bootstrap" position. Reapply the power and you should see the ZMon64 sign-on message. |
| |
| For TeraTerm users in Windows environment, the remaining software can be installed using a [[:builderpages:plasmo:z80mb64:newcfmacro|TeraTerm Macro]] here: |
| |
To install CP/M 2.2, load {{:builderpages:plasmo:z80sbc64:cpm22all_z80sbc64.zip|cpm22all.hex}} and type '**c2**' to copy cpm22 CCP/BDOS/BIOS to track 0 of CF disk. Type "**xA**" to clear the directory of CF drive A:, "**xB**" to clear the directory of drive B:, etc. load {{:builderpages:plasmo:z80sbc64:xmodem.hex|XMODEM.HEX}} in ZMon64 and then type '**b2**' to boot CP/M 2.2. At CP/M prompt, a>, type | To install CP/M 2.2, load {{:builderpages:plasmo:z80sbc64:cpm22all_z80sbc64.zip|cpm22all.hex}} and type '**c2**' to copy cpm22 CCP/BDOS/BIOS to track 0 of CF disk. Type "**xA**" to clear the directory of CF drive A:, "**xB**" to clear the directory of drive B:, etc. load {{:builderpages:plasmo:z80sbc64:xmodem.hex|XMODEM.HEX}} in ZMon64 and then type '**b2**' to boot CP/M 2.2. At CP/M prompt, a>, type |